Set Your Ipv4 Settings - TRENDnet TEG-448WS User Manual

TRENDnet User's Guide

Set your IPv4 settings

System > IPv4 Setup
This section allows you to change your switch IPv4 address settings. Typically, the IP
address settings should be changed to match your existing network subnet in order to
access the switch management page on your network.
Default Switch IPv4 Address: 192.168.10.200
Default Switch IPv4 Subnet Mask: 255.255.255.0
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on IPv4 Setup.
3. Review the settings. When you have completed making changes, click Apply to save
the settings.
• System MAC Address: Displays the switch MAC address information.
• System IP Address: Enter the new switch IP address. (e.g. 192.168.200.200)
• System Subnet Mask: Enter the new switch subnet mask. (e.g. 255.255.255.0)
• System Default Gateway: Enter the default gateway IP address. (e.g.
192.168.200.1 or typically your router/gateway to the Internet).
• System IP Mode: Click the drop-down list and select Static to manually specify
your IP address settings or DHCP to allow your switch to obtain IP address
settings automatically from a DHCP server on your network.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your switch management page"
4. Click Apply.
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-448WS
10