Enable Dhcp Auto Configuration; View And Setup Your Switch Logging - TRENDnet TEG-448WS User Manual

TRENDnet User's Guide

Enable DHCP Auto Configuration

System > DHCP Auto Configuration
If you need to automatically update the switch configuration files via a remote server,
the DHCP Auto Configuration feature is available for this purpose via the DHCP server.
Your IP address settings must enable the DHCP client so that this feature can operate
with your DHCP server.
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on DHCP Auto Configuration.
3. Click the Auto Configuration State drop-down list and select Enabled. Click Apply to
save changes.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your switch management page"

View and setup your switch logging

System > System Log Settings
The system log is designed to monitor the operation the switch by recording the event
messages it generates during normal operation. These events may provide vital
information about system activity that can help in the identification and solutions of
system problems.
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on System Log Settings.
3. Review the settings. Click Apply to save changes.
• Time Stamp
Enable - Each event message recorded in the log will have a time
o
stamp.
Disable - No time stamp will be included with the event messages.
o
• Message Buffered Size - Enter the message buffer size. (Range: 1-200)
• Syslog - Allows you to send device logging to an external log (Syslog) server for
troubleshooting or monitoring.
Syslog Status –
o
Enable – Enable syslog and in the Syslog Server IP section,

enter the IPv4 or IPv6 address of the external syslog server to
send logging.
Disable – Disable syslog functionality.

Facility - Click the drop-down list and which facility to store the
o
logging. (Options: local0 – local7)
Note: You can define the facility to store logging on your external
syslog server. This helps to ensure you have separate logging sections
for different devices.
TEG-448WS
"Access your switch management page"
18