Configure Rate Control - TRENDnet TEG-448WS User Manual

TRENDnet User's Guide

Configure Rate Control

Access Control Config > Rate Control
The Policy Settings page allows you to specify the filtering criteria for one policy. You
can create, modify or delete a Policy by following the procedures in the following
sections:
1. Log into your switch management page (see
on page 7).
2. Click on Access Control Config and click on Rate Control.
3. Review the settings.
•
Enter a number in the Index field. The Index is a unique number within the
range of 1–65535 which identifies the policy. This field is mandatory.
• Enter a number in the Committed Rate column ranging from 1 to 15625.
• Click Add to add the rate control settings to the Rate Control Table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your switch management page"
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-448WS
55