Brother MFC620CN Service Manual page 195

Reassembling Notes
• If you replace the ink absorber box (without replacing the main PCB), you need to reset the
purge counter in the EEPROM to zero according to the procedure below.
MFC620CN/425CN/420CN/410CN/215C/210C and FAX2440C
1) Press the Menu/Set and Black Start keys. Next press the
machine enter the maintenance mode.
The "
TIP: FAX models equipped with numerical keypads can enter the maintenance mode in the
same way as conventional models; that is, by pressing the Menu/Set, *, 2, 8, 6 and 4 keys in
this sequence.
2) Press the 8 and 0 keys in this order to display the equipment's log. (Function code 80
described in
3) Press the Black Start key several times until the purge count appears on the LCD.
4) Press the 2, 7, 8 and 3 keys to reset the purge count to zero.
5) Press the 9 key twice to return to the standby state.
DCP315CN/310CN/120C/117C/110C
1) Press the Menu and Mono Start keys. Next press the
enter the maintenance mode.
The "
2) Display the equipment's log (with Function code 80) by using the
Press the
key several times to display 0 and press the Set key.
3) Press the Mono Start key several times to display the purge count on the LCD.
4) Reset the purge count to zero by using the
Press the
way, enter 7, 8, and 3.
5) Exit from the maintenance mode by using the
Press the
press the
" appears on the LCD.
Chapter 8, Section 8.5.21.)
" appears on the LCD.
key several times to display 8 on the LCD and press the Set key. Again press the
key several times to display 2 on the LCD and then press the Set key. In the same
key several times to display 9 on the LCD and then press the Set key. Again
key several times to display 9 and press the Set key.
key four times to make the machine
and Set keys as follows:
and Set keys as follows:
5-57
key four times to make the
and Set keys as follows:
Confidential