Firmware Switch Setting And Printout (Function Codes 10 And 11) - Brother MFC620CN Service Manual

8.5.4 Firmware Switch Setting and Printout (Function codes 10 and 11)

[ A ] Firmware switch setting
Function
The machine incorporates the following firmware switch functions which can be activated with the
procedures using the control panel keys.
The firmware switches have been set at the factory in conformity to the communications standards
and codes of each country. Do not disturb them unless necessary. Some firmware switches may not
be applicable in some versions. The firmware switch data list indicates "Not used." for those
inapplicable switches.
WSW No.
WSW01
WSW02
WSW03
WSW04
WSW05
WSW06
WSW07
WSW08
WSW09
WSW10
WSW11
WSW12
WSW13
WSW14
WSW15
WSW16
WSW17
WSW18
WSW19
WSW20
WSW21
WSW22
WSW23
WSW24
WSW25
WSW26
WSW27
WSW28
WSW29
WSW30
WSW31
WSW32
WSW33
Firmware Switches (WSW01 through WSW51)
Dial pulse setting
Tone signal setting
PABX mode setting
TRANSFER facility setting
1st dial tone and busy tone detection
Pause key setting and 2nd dial tone detection
Dial tone setting 1
Dial tone setting 2
Protocol definition 1
Protocol definition 2
Busy tone setting
Signal detection condition setting
Modem setting
AUTO ANS facility setting
REDIAL facility setting
Function setting 1
Function setting 2
Function setting 3
Transmission speed setting
Overseas communications mode setting
TAD setting 1
ECM and call waiting caller ID
Communications setting
TAD setting 2
TAD setting 3
Function setting 4
Function setting 5
Function setting 6
Function setting 7
Function setting 8
Function setting 9
Function setting 10
Function setting 11
Function
8 - 1 2 Confidential