Port Access Control; Authenticator State - D-Link DES-6500 Manual

Port Access Control

The following screens are used to monitor 802.1x statistics of the Switch, on a per port basis. To view the Port Access
Control screens, open the monitoring folder and click the Port Access Control folder. There are six screens to monitor.

Authenticator State

The following section describes the 802.1X Status on the Switch. To view the Authenticator State, click Monitoring >
Port Access Control > Authenticator State.
DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
NOTE: The Authenticator State, Authenticator Statistics, Authenticator
Session Statistics and Authenticator Diagnostics windows in this
section cannot be viewed on the DES-6500 switch unless 802.1x is
enabled by port or by MAC address. To enable 802.1x, go to the Port
Access Entity folder in the configuration folder and select the heading
802.1X Auth Mode Settings.
Figure 9- 17. Authenticator State window – Port-based 802.1x
249