D-Link DES-6500 Manual page 158

Field
Network Mask
Options
Hello Interval
Router Priority
Router Dead Interval
Designated Router
Backup Designated
Router
Field
Neighbor
Database Description Packet
Database Description packets are OSPF packet type 2. These packets are exchanged when an adjacency is being initialized.
They describe the contents of the topological database. Multiple packets may be used to describe the database. For this
purpose, a poll-response procedure is used. One of the routers is designated to be master, the other a slave. The master
seconds Database Description packets (polls) that are acknowledged by Database Description packets sent by the slave
(responses). The responses are linked to the polls via the packets' DD sequence numbers.
Version No.
Reserved
DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
Description
The network mask associated with this interface.
The optional capabilities supported by the router.
The number of seconds between this router's Hello packets.
This router's Router Priority. The Router Priority is used in the
election of the DR and BDR. If this field is set to 0, the router is
ineligible become the DR or the BDR.
The number of seconds that must pass before declaring a silent
router as down.
The identity of the DR for this network, in the view of the
advertising router. The DR is identified here by its IP interface
address on the network.
The identity of the Backup Designated Router (BDR) for this
network. The BDR is identified here by its IP interface address on
the network. This field is set to 0.0.0.0 if there is no BDR.
Description
The Router IDs of each router from whom valid Hello packets have
been seen within the Router Dead Interval on the network.
Database Description Packet
2
Router ID
Area ID
Checksum
Authentication
Authentication
I M MS
Reserved
DD Sequence No.
Link-State Advertisement Header ...
Figure 6- 119. Database Description Packet
Packet Length
Authentication Type
Options
157