D-Link DES-6500 Manual page 104

To establish the rule for a previously created Access Profile:
In the Configuration folder, click the Access Profile Table link opening the Access Profile Table. Under the heading
Access Rule, clicking Modify, will open the following window.
To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously
created rule, click the corresponding
Configure the following Access Rule Configuration settings for IP:
Parameter
Profile ID
Mode
Access ID
DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
Figure 6- 59. Access Rule Table window – IP
button.
Figure 6- 60. Access Rule Configuration window (IP)
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 - 100.
103