Adding Runtime R1.01 Des-6505/Des-6507/Des-6509 Line Cards To The Runtime R1.30/1.4/2.0/2.5 Chassis - D-Link DES-6500 Manual

Adding Runtime R1.01 DES-6505/DES-6507/DES-6509 Line Cards to the
Runtime R1.30/1.4/2.0/2.5 Chassis
For owners of the DES-6500 chassis switch, certain software incongruencies have surfaced with the adding and removing
new line cards in the chassis. If a DES-6500 chassis switch has been uploaded with R1.30/1.4/2.0/2.5 or later runtime code,
and yet line cards DES-6505/DES-6507/DES-6509 are R1.01, line cards DES-6504/DES-6508/DES-6510/DES-6512
cannot be recognized by the chassis' CPU. To solve this problem, first remove the DES-6504/DES-6508/DES-6510/DES-
6512 line cards from the chassis, upgrade the DES-6505/DES-6507/DES-6509 to R1.30/1.4/2.0/2.5 and then re-insert the
DES-6504/DES-6508/DES-6510/DES-6512 line cards into the chassis. The system should be recovered and the chassis
should function normally. Follow the following steps to guide you through the process.
Step 1
Execute the "show switch" command to confirm the CPU firmware status currently set on the chassis.
DES-6500:4#show switch
Command: show switch
Device Type
MAC Address
IP Address
VLAN Name
Subnet Mask
Default Gateway
Boot PROM Version : Build 2.00-B20
Firmware Version
Hardware Version
Device S/N
System Name
System Location
System Contact
Spanning Tree
GVRP
IGMP Snooping
802.1X
Jumbo Frame
Clipaging
Port Mirror
SNTP
Boot Relay
DNSR Status
VRRP
DVMRP
PIM-DM
RIP
OSPF
TELNET
WEB
RMON
HOL Prevention State : Enabled
Syslog Global State
DES-6500:4#
DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
: DES-6500 Chassis Ethernet Switch
: DA-10-21-00-00-01
: 10.41.44.22 (Manual)
: default
: 255.0.0.0
: 0.0.0.0
: Build 2.50-B12
: 2A1
:
: DES-6500_#3
: 7th_flr_east_cabinet
: Julius_Erving_212-555-6666
: Disabled
: Disabled
: Disabled
: Disabled
: Off
: Enabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled (TCP 23)
: Enabled (TCP 80)
: Enabled
: Disabled
298