User Settings - Eaton Powerware 9155 User Manual

OPERATION
Table 4. User Settings
Description
Set Date and Time
Display Contrast
Change Language
Relay Config
Signal Inputs
Serial Port Config
Parallel Operation Settings
42 EATON Powerware

User Settings

The following table displays the options that can be changed by the
user.
NOTE Changes to the output voltage or frequency options should be made before turning
on the UPS; otherwise, the changes do not take effect.
Available Settings
Set Month
Date: mm/dd/yyyy
Time: 24:00
Adjust contrast with up/down arrow buttons
Select Language: <English>
Elegir idioma <Español>
Relay: [Alarm 1] [X-Slot 1-1/2/3/4] or
[X-Slot 2-1/2/3/4]
Setup: [empty] [On Battery] [summary alarm]
[On Bypass] [UPS ok] [custom]
[empty] [Logic]
Signal Input must be wired to the CAN Bridge
Card (see Figure 19 on page 27).
For more information, refer to "Programmable
Signal Inputs" in the Powerware 9155 UPS
(8–15 kVA) User's Guide.
Port: [X-Slot-1] [X-Slot-2/Serv]
Speed: [19200] [9600] [2400] [1200]
Parallel Unit Number: [Single Unit] [Unit #1]
[Unit #2] [Unit #3]
Start Auto Calibration: [Press
Redundant Mode
Capacity Mode
® 9155 Parallel UPS (8–15 kVA) User's Guide
Default Setting
01/01/2003
00:00
Moderate
English
Alarm 1: empty
X-Slots (1 or 2)
#1: UPS ok
#2: On Bypass
#3: Summary Alarm
#4: On Battery
<empty>
19200
Single Unit
]
Redundant Mode
S 164201592 C www.eaton.com/powerquality