Profile - Grandstream Networks GXW-410 User Manual

D P
IAL LAN
The Dial Plan feature implemented is applicable for VOIP to PSTN calls only. You may configure a dial
plan based on the following grammar:-
1. Accept Digits: 1,2,3,4,5,6,7,8,9,0,*,#
2. Grammar:
x - any digit from 0-9;
xx+ - at least 2 digit number;
^ - exclude;
[3-5] - any digit of 3, 4, or 5;
[147] - any digit 1, 4, or 7;
<2=011> - replace digit 2 with 011 when dialing
WARNING - illegal input will fall back to default
Example 1: {[369]11 | 1617xxxxxxx} - Allow 311, 611, 911, and any 10 digit numbers of leading
digits 1617.
Example 2: {^1900x+ | <=1617>xxxxxxx} - Block any number of leading digits 1900 and add
prefix 1617 for any dialed 7 digit numbers.
Example 3: {1xxx[2-9]xxxxxx | <2=011>x+} - Allow any length of number with leading digit 2 and
10 digit-numbers of leading digit 1 and leading exchange number between 2 and 9;
If leading digit is 2, replace leading digit 2 with 011 before dialing
Default: PSTN Outgoing - {x+}
Note – If you do not plan to use this feature just let it be default {x+}
P
ROFILES
Profiles are basically IP PBX / SIP Server configuration templates. If you have more than one IP PBX
system or SIP Server that you would like to use with the GXW410x, then you can configure Profile 2 or 3.
Note – Make sure you select the correct profile for each channel under Channels
T 11: P P
ABLE ROFILE AGE
Activate Profile When set to Yes the SIP Profile is activated.
Profile Name A name to identify a Profile.
SIP Server SIP Server's IP address or Domain name provided by VoIP service provider.
Outbound Proxy IP address or Domain name of Outbound Proxy, or Media Gateway, or Session
Border Controller. Used by GXW-410x for firewall or NAT penetration in different
network environments. If symmetric NAT is detected, STUN will not work and
ONLY outbound proxy can correct the problem.
Use DNS SRV: Default is No. If set to Yes the client will use DNS SRV to look up server.
User ID is Phone If the GXW-410x has an assigned PSTN telephone number, this field should be set
Number to "Yes". Otherwise, set it to "No". If "Yes" is set, a "user=phone" parameter will be
attached to the "From" header in SIP request.
Grandstream Networks, Inc.
D
EFINITIONS
GXW-410x User Manual
Firmware 1.0.0.53
.
WEBPAGE
Page 23 of 37
Updated: 04/2007