Profiles; Table 12: Channels Page Definitions; Table 13: Profile Page Definitions - Grandstream Networks GXW410 User Manual

T 12: C P D
ABLE HANNELS AGE
Dial Plan
Hook flash Duration
(X10ms)
Use DTMF Parameter
from RFC2833 or SIP Info
DTMF Digit Length
DTMF Digit Volume
DTMF Dial Pause
P
ROFILES
Profiles are basically IP­PBX / SIP Server configuration templates. If you have more than one IP­PBX
system or SIP Server that you would like to use with the GXW410x, then you can configure Profile 2 or 3.
Note: Make sure you select the correct profile for each channel under Channels
T 13: P P D
ABLE ROFILE AGE
Activate Profile When set to Yes the SIP Profile is activated.
Profile Name A name to identify a Profile.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
EFINITIONS
The Dial Plan feature implemented is applicable for VOIP to PSTN calls only. You may
configure a dial plan based on the following grammar:
1. Accept Digits: 1,2,3,4,5,6,7,8,9,0,*,#,A,a,B,b,C,c,D,d
2. Grammar:
x ­ any digit from 0­9;
xx+ ­ at least 2 digit number;
xx. ­ at least 2 digit number;
^ ­ exclude;
[3­5] ­ any digit of 3, 4, or 5;
[147] ­ any digit 1, 4, or 7;
<2=011> ­ replace digit 2 with 011 when dialing
WARNING ­ illegal input will fall back to default
Example 1: {[369]11 | 1617xxxxxxx} ­ Allow 311, 611, 911, and any 10 digit
numbers of leading digits 1617.
Example 2: {^1900x+ | <=1617>xxxxxxx} ­ Block any number of leading digits 1900
and add prefix 1617 for any dialed 7 digit numbers.
Example 3: {1xxx[2­9]xxxxxx | <2=011>x+} ­ Allow any length of number with
leading digit 2 and 10 digit­numbers of leading digit 1 and leading exchange number
between 2 and 9;
If leading digit is 2, replace leading digit 2 with 011 before dialing
Default: PSTN Outgoing ­ {x+}
Note: If you do not plan to use this feature set to default {x+}
Default 600ms. This value can accept any value in the 100­2000ms range.
Default Yes, No means to use DTMF parameter settings according to DTMF Digit
Length, DTMF Digit Volume and DTMF Dial Pause.
Default value is 100ms. Please not that the value will be multiplied by 10ms
Default value is ­11dB.
Default value is 100ms. Please note that the value will be multiplied by 10ms.
EFINITIONS
PAGE