Table 11: Profile Settings; Firmware Version 1.0.10.9 - Grandstream Networks GXW400X User Manual

Offhook Auto-dial
Offhook Auto-Dial
Delay
Map to FXO Port#
Map to FXO Gateway IP This is used when peering with an FXO gateway of any brand. You have to specifically
and Port
Profile Active
When set to Yes the SIP Profile is activated.
Primary SIP Server's IP address or Domain name provided by VoIP service provider.
Primary SIP Server
Failover SIP Server's IP address or Domain name provided by VoIP Service provider.
Failover SIP Server
This server will be used if the Primary SIP server becomes unavailable.
Prefer Primary SIP Default is no. If set to yes it will register to Primary Server if registration with Failover
Server
server expires
Outbound Proxy IP address or Domain name of Outbound Proxy, or Media Gateway, or Session Border
Controller. Used by GXW40XX for firewall or NAT penetration in different network
environments. If symmetric NAT is detected, STUN will not work and ONLY outbound
proxy can correct the problem.
User can select UDP or TCP or TLS. Please make sure you're SIP Server or network
SIP transport
environment supports SIP over the selected transport method. Default is UDP.

FIRMWARE VERSION 1.0.10.9

60
This feature allows you to automatically dial the number specified in this field as soon
as the port is offhooked, i.e. when the receiver on the phone connected to Port# is
picked up.
Configure the delay time for offhook auto-dial function. Range is
default is 0.
This is used only when peering with a Grandstream GXW410x. Default is 1,
Supported values are 1-8, meaning line 1 to line 8 of the GXW410x device where the
port will be mapped to.
mention the IP and sip port where the call will be sent to.
Sip port that will be annexed to the IP address above.

TABLE 11: PROFILE SETTINGS

GXW40XX USER MANUAL
0-60 seconds,
Page 44 of