Led And Feed Switch - Intermec EasyCoder PC4 Service Manual

4.2 LED and Feed Switch

Description
Replacement
Cable cover
Isolation sheet
Feed switch PCB
Intermec EasyCoder PC4—Service Manual
The LED control lamp and Feed switch are fitted on the same Feed Switch
PCB inside a housing on the left side of the print frame. The board is con-
nected to JP9 on the main board via a four cables that run inside the left
side hinge of the print frame. The control lamp shines through a transpar-
ent window and the Feed switch is activated via a dome, both in the name
plate on the top cover.
Color
Green (solid)
Green (flashing)
Red (solid)
Red (short flashes)
Red (long flashes)
Orange
Dark
The Feed Switch PCB can be accessed for replacement by removing the
cable cover, which is held in place by a Phillips screw and a snap lock. The
Feed Switch PCB is inserted between two rails in the moulding and is cov-
ered by an isolation sheet.
Screw
Print frame
Meaning
Media loaded
Ribbon loaded (TTR only)
Receiving data
(Test Mode only)
Out of media
Out of ribbon (TTR only)
Printer reset
Upgrading firmware
Overtemperature
Media jam in cutter
Overheated printhead or
stepper motor
Error condition detected
Power off
Chapter 4 —Print Fram
Snap lock
19