Table of Contents
Advertisement
The two-line display will always show two of the following basic menu options:
Displayed data
Samples
Analog output
Output function
Electrode clean
Serial line
Production data
Dose setting
Zero setting
100 percent
Exit
Display reading: the basic menu
Use push-buttons
and
selected item is on the first display line with the initial character blinking.
Depress push-button
depress push-button
the Escape command will bring forth the possibility to terminate the programming mode via the selection
of the "Exit" item of the basic menu.
7.1. Programming of the basic menu items
7.1.1. Displayed data
The "Displayed data" menu allows the operator to choose which parameters are to be displayed. Using
push-buttons
and
cancelled.
Menu: Displayed data, depress
The two-line display unit will always show two of the items from the following menu. Use push-buttons
to page upwards and downwards through the menu items.
Flow rate
Total volume +
Total volume -
Total difference
Operational time
Percent. Flow rate
Last error
Dosing mode
Menu: Displayed data, depress
Display line 1 will read "Do not display", line 2 "l/s .... l". Use push-buttons
menu items. If you choose "Do not display", depress
display If you wish to display "Total volume +", select the"Total Volume +" item on the menu; depress push-
button
skip line 1,(Do not display) and select line 2, "l/s .... l" (flow-rate unit ... volume unit). Using push-
buttons
(downwards) and
selection by depressing
(downwards) and
(upwards), select the desired number of decimal positions, confirm the selection by
depressing
and return to the "Displayed data" menu.
Design, Assembly and Service Manual
Induction flow meter FMG600 series
to move upwards and downwards in the menu. As in any meter menu, the
to enter a subordinated menu, or to edit an item. When in a subordinated menu,
to return to the higher-level menu (the "Escape" function). When in the basic menu,
, select parameters from the following list. The Flow Rate display cannot be
/ Total volume depress
(upwards), select the desired flow-rate and volume units and confirm the
. The display line 1 will then show "0" and line 2 "0.0".Using push-buttons
and
to return to the "Displayed data" menu. If you wish to
Page 24 of 44
and
to go up and down in the
Advertisement
Table of Contents
