Table of Contents
Advertisement
Names of Parts and Basic Key Operations
Basic Key Operations
vi
This section describes basic operations on the front panel keys to change various settings.
• Execution Modes
The recorder has the following execution modes.
• Operation mode: A mode used to perform recording and monitoring.
• Setting mode: A mode used to set the input range, alarms, chart speed, and other
parameters.
• Basic Setting mode: A mode used to set the basic specifications of functions with
the recording operation stopped.
* In the explanation of commands in (chapter 4), Run mode collectively refers to
Operation mode and Setting mode.
Settings related to communications are configured in Basic Setting mode. You
cannot enter Basic Setting mode while the recorder is recording or while
computation is in progress on the computation function (/M1 option).
• Entering Basic Setting Mode
Hold down the
key for 3 seconds.
MENU
The Setting mode display appears.
Set=Range
Input range and s
The panel keys are set to the functions marked above the keys as shown below.
CHARACTER
RCD
MENU
DISP
FUNC
Hold down both the
The Basic Setting mode display appears. The top and bottom lines are the setup item
and comment, respectively. The section that is blinking in the setup item that you
change. In this manual, the section that you change appears shaded.
The comment line shows useful information such as a description of the setup item
and the range of selectable values. Read the comment and change the items as
necessary.
Setup item
Basic=Alarm
Comment
Auxiliary alarm
• Selecting the Setup Item and Value
The selected item change each time you press the
item change in reverse order if you press the
SHIFT (
) key.
FEED
Basic=Ethernet
This manual denotes the operation of pressing a key while holding down the SHIFT
(
) key as SHIFT + the other key (for example: SHIFT +
FEED
After you make a selection, press the
When the Setting Complete screen appears, the changed item is applied.
Ethernet host
Setting complete
• Using the ESC Key
If you press the ESC (
1
a higher level menu. If you do not show the Setting Complete screen, the changes
you made up to that point are discarded.
You can show and hide the comment on the bottom line by pressing the ESC (
key while holding down the SHIFT (
ESC/?
SHIFT
MENU
FEED
CH UP
1
(
) key and the
DISP
Selections
(
) key. The next screen appears.
CH UP
) key, the operation is cancelled, and the display returns to
MENU
) key.
FEED
(
) key for 3 seconds.
FUNC
The item to be controlled blinks.
(
) key. The selected
DISP
(
) while holding down the
DISP
key).
)
1
MENU
Advertisement
Table of Contents
