Cisco ASR 900 Series Release Notes page 111

Chapter
CSCuf07508
•
Symptom: The Gigabit Ethernet port on interface module does not come up after a reload.
Conditions: This issue occurs when the Cisco ASR 903 router is reloaded multiple times.
Workaround: Perform an OIR of the interface module.
CSCuf79397
•
Symptom: The F1 interface is stuck in init state after OIR of the standby RSP or standby reload.
Conditions: This issue occurs after the standby RSP is reloaded or OIR is performed.
Workaround: There is no workaround.
CSCub94462
•
Symptom: The router displays object download error messages on the console similar to the
following example:
%FMFP-3-OBJ_DWNLD_TO_CPP_FAILED"
Conditions: Occurs when you take the following actions:
–
–
–
–
Workaround: Do not issue clear mac-address-table command when the mac security sticky is
configured.
• CSCue51682
Symptom: The REP protocol flaps, as indicated by the following error messages:
*Feb
non-operational due to neighbor not responding
*Feb
operational
Conditions: Occurs under the following conditions:
–
–
–
Workaround: Remove fast LSL from the REP configuration.
CSCuf86247
•
Symptom: SNMP MIB variables related to BDI counters do not function properly.
Conditions: Occurs when you use SNMP MIB variables related to BDI interface counters.
Workaround: There is no workaround.
CSCug05491
•
Symptom: The router drops traffic on VPLS circuits.
Conditions: Occurs when you take the following actions:
–
–
OL-26630-12
Apply the mac address sticky command
Configure 25 incremental MAC addresses
Apply the clear mac-address-table bdomain command
Remove a mac security sticky configuration from an EVC interface
8 06:51:38.857: %REP-4-LINKSTATUS: GigabitEthernet0/0/1 (segment 10) is
8 06:51:39.096: %REP-4-LINKSTATUS: GigabitEthernet0/0/1 (segment 10) is
The router is sending traffic using the incremental MAC address table
Fast LSL is configured using a 200ms timer.
The router is configured with more than 2000 MAC addresses.
Configure REP with VLAN load balancing
Configure VPLS VFI on the VLANs
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.7S Releases
23