Cisco ASR 900 Series Release Notes page 140

Caveats in Cisco IOS XE 3.7S Releases
–
–
–
–
Workaround: There is no workaround.
CSCua96186
•
Symptom: The router drops cells on a CE-to-CE connection.
Conditions: Occurs with ATM VCC and VPC cell relay mode with 64-byte traffic. The issue occurs
between the ASR 903 and ASR 901 routers.
Workaround: There is no workaround.
CSCub04699
•
Symptom: The bandwidth and bandwidth percent commands do not function correctly.
Conditions: Occurs when you configure a service-policy with the priority and police commands in
one class and the bandwidth or bandwidth percent commands in another class.
Workaround: There is no workaround.
CSCub48081
•
Symptom: The router does not learn remote MEPs on an EVC bridge-domain MEP following an
interface module reset (soft OIR). The router displays messages indicating object download failure;
the interface status of the xconnect MEP on the peer router displays as administratively down.
Conditions: Occurs when you
–
–
–
Workaround: Remove and restore the local MEP configuration on both routers.
• CSCub55760
Symptom: The router displays a Delay Measurement Message (DMM) delay value of 0.
Conditions: Occurs under the following conditions:
–
–
Workaround: Configure PTP synchronization before scheduling DMM.
CSCub60668
•
Symptom: The router is unable to establish an OSPF session.
Conditions: Occurs when you enable an OSPF session over an MPLS TP tunnel.
Workaround: There is no workaround.
CSCub69132
•
Symptom: The OC-3 interface module crashes.
Conditions: Occurs when you issue a soft reload on the OC-3 interface module when the
router is configured with MLPPP at a high scale.
Workaround: There is no workaround.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
52
The policy is attached to the main interface.
The policy classifies on multiple VLANs.
The classification statements specify a priority.
The classification statements are within a child QoS policy.
Configure offloaded EVC xconnect MEP sessions and the sessions are active
Configure EVC bridge-domain MEPs
Perform a reset (soft OIR) of the Ethernet interface module
You configure an EVC down MEP on a port-channel interface.
You dynamically add a member link to a port-channel interface.
Chapter
OL-26630-12