Resolved Caveats-Cisco Ios Xe Release 3.10S - Cisco ASR 900 Series Release Notes

Caveats in Cisco IOS XE 3.10S Releases
Resolved Caveats—Cisco IOS XE Release 3.10S
This section documents the issues that have been resolved in Cisco IOS XE Release 3.10S.
•
•
•
•
•
•
•
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
20
CSCtx70302
Symptom: Traceback and log messages are seen while performing a multilink bundle shutdown on
the Cisco ASR 903 router.
Conditions: This issue is observed when traffic flows over the multilink bundle.
Workaround: There is no workaround. This issue does not impact the operation of the router.
CSCua61934
Symptom: When a policy map with priority in class-default is attached to an interface, it is not
rejected.
Conditions: This issue is observed when you configure policy-map having priority in class-default
and attach the policy to an interface.
Workaround: There is no workaround.
CSCua90879
Symptom: QoS policies with a police statement on the class-default class do not take effect.
Conditions: This issue is observed when you apply a police statement to the class-default class
within a QoS policy on an ingress EVC interface.
Workaround: Apply the police statement to a static class, such as class cos0.
CSCuc59386
Symptom: IOMD crashes continuously on OC-3 IM. The interfaces on OC-3 IM are not
configurable and the following error message is displayed:
stand-by does not support this command
Conditions: This issue is observed on a Cisco ASR 903 router high availability setup with OC-3 IM.
Workaround: Reload the standby RSP.
CSCuc60148
Symptom: The router does not shut down when the temperature sensor reaches the shutdown
threshold.
Conditions: Temperature sensor reaches shutdown threshold.
Workaround: Use the facility-alarm critical exceed-action shutdown commands to enable
system shutdown.
CSCuc83088
Symptom: The router drops traffic while performing a Stateful Switchover (SSO).
Conditions: This issue is observed when the router is running HSRP or VRRP. It occurs when the
destination MAC address is a virtual MAC (vMAC) address.
Workaround: Change the traffic priority and detour traffic before performing an SSO.
CSCud09100
Symptom: The router accepts a policy with marking at two levels. It should not accept a policy with
marking at two levels.
Conditions: This issue is observed when you apply a policy with marking at two levels.
Chapter
OL-26630-12