Cisco ASR 900 Series Release Notes page 264

Chapter
CSCug97269
•
Symptom: The serial interface flaps when the neighbor controller is shut.
Conditions: This issue occurs occurs on performing shutdown on peer OC-3 controller with ATM or
IMA channels.
Workaround: There is no workaround.
CSCuh83433
•
Symptom: The path level controllers status on OC-3 IM sonet controller is not displayed after a
second SSO is triggered manually after removing the RSP.
Conditions: This issue is seen on hard RSP reset of RSP1.
Workaround: Perform a controller shutdown followed by a no shut down.
CSCui08697
•
Symptom: The interface LED glows green after SSO.
Conditions: This issue occurs after an SSO is performed and shut down of the ports on the router.
Workaround: There is no workaround.
CSCui34041
•
Symptom: Traffic does not flow on one of the prefix of the MPLS template.
Conditions: This issue occurs when the MAX MPLS label of that template is assigned to that prefix
Workaround: Disable and enable that prefix.
• CSCui41169
Symptom: The active card reloads when standby become active after switchover with scaled
configurations.
Conditions: This issue occurs with 4000 EVCs with first and second level ingress policy. The Ingress
policy has one policer and the egress policy has one parent and child policer. This issue occurs with
reloading the card with this configuration.
Workaround: There is no workaround.
CSCui53268
•
Symptom: Adding a child policy map with Vlan class to parent PHB class dynamically, does not
trigger the error message.
Conditions: This issue occurs when a PHB level policy is attached to an interface and any policy is
being dynamically added as a child to one of the existing PHB classes.
Workaround: Detaching the policy and performing a modification and trying to reattach displays the
error.
CSCui62568
•
Symptom: No error reported when invalid policer is dynamically modified to remove the PIR
configuration with violate-action.
Conditions: This issue occurs when a policy-map with CIR and PIR value attached to an EFP is
dynamically modified to just CIR which make the policer have exceed action without PIR.
Workaround: Remove the violate-action first and then remove PIR configuration.
OL-26630-12
Caveats in Cisco IOS XE 3.10S Releases
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
10