Cisco ASR 900 Series Release Notes page 284

Caveats in Cisco IOS XE 3.10S Releases
CSCug31212
•
Symptom: When you apply a policy map, the console shows an error message.
Conditions: This issue is observed when you apply a policy map with numbered ACLs.
Workaround: There is no workaround.
CSCug31645
•
Symptom: If you change the template on the router and change it again within two minutes, the
standby RSP is unable to synchronize with the new template and the router reloads twice.
Conditions: This issue is observed when you change the template, and change it again within two
minutes before reloading the router.
Workaround: Do not change the template and change it again within two minutes.
CSCug44762
•
Symptom: The POS interface stays down after using the shutdown and no shutdown commands.
Conditions: This is issue is observed when you use the shutdown and no shutdown commands on
the POS interface.
Workaround: Use the shutdown and no shutdown commands on the controller.
CSCug48534
•
Symptom: Multicast traffic is forwarded on untagged EFPs when snooping is enabled.
Conditions: This issue is observed when untagged EFPs are shutdown at least once after it comes
up.
Workaround: Reload the router or toggle IGMP snooping.
CSCug55586
•
Symptom: If you dynamically remove the egress markings, ingress marking does not work.
Conditions: This issue is observed if a marking is present at the logical level in the egress direction,
DM does not work.
Workaround: Use the egress set at leaf or PHB level.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
30
Chapter
OL-26630-12