Cisco ASR 900 Series Release Notes page 230

Caveats in Cisco IOS XE 3.9S Releases
Workaround: Use different timeslots, or make sure channel-group and cem-group numbers are
different under the same controller
• CSCua57325
Symptom: The router displays an OIR SPA error.
Conditions: Occurs under the following conditions:
–
–
–
–
–
CSCua61934
•
Symptoms: When policy-map with priority in class-default is attached to interface its not getting
rejected.
Conditions: Configure policy-map having priority in class-default. Attach the policy to interface
it's not getting rejected.
–
CSCua77688
•
Symptom: The router experiences remote CFM MEP flapping.
Conditions: Occurs when the router is connected via a CFM xconnect and the link is running a high
traffic rate.
Workaround: Reduce the rate of traffic.
CSCua90879
•
Symptom: QoS policies with a police statement on the class-default class do not take effect.
Conditions: Occurs when you apply a police statement to the class-default class within a QoS policy
on an ingress EVC interface.
Workaround: Apply the police statement to a static class, such as class cos0.
CSCub18160
•
Symptom: The router drops traffic on a link twice and displays a remote fault error message.
Conditions: Occurs when you issue an interface module reset (OIR) while the 10.000M XFP
(DWDM Edge performance) or XFP10GER-192IR-L XFPs are plugged into the ten Gigabit
Ethernet interface module and active.
Reloading the router also takes significantly longer when using these XFPs.
Workaround: There is no workaround.
CSCub26877
•
Symptoms: When Bridge-domain of the efp is changed and the new bridge-domain is not accepted,
the old bridge-domain gets rejected.
Conditions: EVC -BD configuration change.
Workaround: None
CSCub33576
•
Symptoms: All IMA interfaces does not come up until OIR of IM.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
34
The router is running offloaded CFM sessions over an xconnect (pseudowire) interface.
The router is using a redundant hardware (dual RSP) configuration.
The remote router is using a non-redundant (single RSP) hardware configuration.
You reload the router.
Workaround: There is no workaround.
Workaround: None known at this time
OL-26630-12