Manufactured (Mobile) Home Installations - Additional Requirements; Chimney System; Definitions - Osburn 2200 Owner's Manual

1.4 Manufactured (Mobile) Home Installations – Additional Requirements
1. The stove must be bolted to the floor (secure the unit by prying out the two plastic plugs in the
pedestal, and installing the two 3/8" x 3-1/2" (9.8mm x 88.9mm) lag bolts through the holes
provided).
2. The unit
must
3. Clearance from the top of stove to an unprotected ceiling should be a minimum of
52" (1321mm).
Note: For manufactured home installations in the USA, the stove must be grounded to the frame of
the home using a # 8 ground wire with approved terminations and star lock washers.
C :
T
AUTION
HE
R
C :
D
AUTION O
1.5

Chimney System

1.5.1 Definitions

For clarity, the following definitions should be used with respect to these instructions:
A
chimney system
connector and terminates outside the building envelope.
A can be a
chimney
built chimney.
A
factory built chimney
sometimes referred to as an insulated
with insulation between the first and second pipes, and air between the second and third pipes).
A
single walled
A
double walled
be provided with outside combustion air (pedestal model only).
S I
TRUCTURAL NTEGRITY
M B M
OOF UST E AINTAINED
N I I A S
OT NSTALL N LEEPING
consists of the
connector
masonry chimney
can be a
double walled chimney
connector is a single pipe.
connector has two concentric pipes, no insulation, and is an
O T M
F HE ANUFACTURED
.
R .
OOM
off the top of the stove, and a
(of masonry construction with an inside liner), or a
(two concentric pipes with insulation
, or an
solid pack air cooled chimney
H F , W , C
OME LOOR ALL
, which joins to the
chimney
(three concentric pipes,
connector.
air cooled
/
EILING
factory
10