Chimney Cleaning - Osburn 2200 Owner's Manual

3. Push the ashes through the hole and leave some ashes to cover the ash dump plug once it is
replaced. Leave an ash bed of approximately 1" deep on the firebox bottom to help maintain a hot
ember bed.
4. Clear the ashes from the area where the plug normally sits so that it will properly seat
against the opening edges; tap it down with your poker to ensure proper seating.
5. Cover the plug with the remaining ashes and continue operation of your stove as usual. The
Ash Drawer is shown in Figure 3.1 and can be removed by pulling it out toward you. Lift the Ash
Drawer slightly or the pedestal base may get scratched. Close the rear half of the Ash Drawer lid to
prevent spillage. Ashes should be placed in a metal container with a tightly fitting lid. This closed
container should be placed on a non-combustible floor or on the ground, well away from all
combustible materials, pending final disposal. Ensure the rear half of the lid is open before replacing
the Ash Drawer.
If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in
the closed container until all cinders have thoroughly cooled. Do not place other waste materials in
the metal ash container. If bright embers are glowing above the ash dump port during a low or medium
low fire, air may be leaking past the ash plug. If this is happening, a possible over fire hazard exists.
The stove should be shut down and allowed to cool. Properly seal the ash dump plug to the stove.
3.3

Chimney Cleaning

Regular chimney maintenance, as well as good burning practices, are required to prevent chimney
fires. The chimney and the chimney connector pipe must be maintained in good condition and be
kept clean in order to be safe. This means that the chimney should be checked regularly for
creosote build-up. Inspection and cleaning of the chimney is facilitated by a removable baffle.
C : O
AUTION PERATION
H T
AZARDOUS EMPERATURE
Contact your local, municipal, state, or provincial fire authority for information on how to handle a
chimney fire before there is any chance that it may happen.
When wood (especially green wood) is burned without adequate heat or air supply, it produces
tar and other organic vapours (smoke), which combine with expelled moisture to form creosote.
The creosote vapours condense in the relatively cool chimney flue of a slow-burning fire. As a
result, creosote residue accumulates on the flue lining. When ignited, this creosote makes an
Figure 3.1 Ash removal
O Y O 2200 W
F OUR SBURN
C A
ONDITIONS ND
T B
ITHOUT HE AFFLE
W V T W
ILL OID HE ARRANTY
M C U
AY AUSE NSAFE
.
A
ND
23