1.4 Manufactured (Mobile) Home Installations – Additional Requirements
1. The stove must be bolted to the floor (secure the unit by prying out the two plastic plugs in
the pedestal, and installing the two 3/8" x 3-1/2" (9.8mm x 88.9mm) lag bolts through the
holes provided).
2. The unit
must
3. Clearance from the top of stove to an unprotected ceiling should be a minimum of
52" (1321mm).
4.
A pipe shield must be used on the double wall connector. Part # OA10035 shield. See
installation instructions with shield.
Note: For manufactured home installations in the USA, the stove must be grounded to the frame
of the home using a # 8 ground wire with approved terminations and star lock washers.
C
:
T
AUTION
R
C
:
D
AUTION
O
1.5 Chimney System
1.5.1 Definitions
For clarity, the following definitions should be used with respect to these instructions:
A
chimney system
the connector and terminates outside the building envelope.
A
can be a
chimney
built chimney.
A
factory built chimney
sometimes referred to as an insulated
with insulation between the first and second pipes, and air between the second and third pipes).
A
single walled
A
double walled
connector.
1.5.2 Components
All connector and manufactured chimney components must be
N
:
OTE
Masonry Chimneys must be
stainless steel or clay refractory construction).
be provided with outside combustion air.
S
I
HE
TRUCTURAL
NTEGRITY
M
B
M
OOF
UST
E
AINTAINED
N
I
I
A S
OT
NSTALL
N
LEEPING
consists of the
connector
masonry chimney
can be a
double walled chimney
connector is a single pipe.
connector has two concentric pipes, no insulation, and is an
Code Complying
O
T
M
F
HE
ANUFACTURED
.
R
.
OOM
off the top of the stove, and a
(of masonry construction with an inside liner), or a
(two concentric pipes with insulation
, or an
solid pack
air cooled chimney
, and have a
H
F
, W
OME
LOOR
ALL
, which joins to
chimney
(three concentric pipes,
L
C
ISTED
solid fuel burning liner (of
listed
, C
/
EILING
factory
air cooled
.
OMPONENTS
13