Table of Contents
Advertisement
Installation and Setup, cont'd
2.
Follow steps
3
section of this chapter.
AAP Device Features
3
RGB 580xi AAP
AUDIO IN
COMPUTER IN
RGB 580xi
1
2
Power/signal LED — This LED lights
1
•
amber to indicate that the AAP device is receiving power.
•
green to indicate that an active sync signal is present at the
input and that the AAP device is receiving power.
The LED flashes green whenever the minimum and
maximum limits of the horizontal shift control (H. shift)
have been reached.
RGB video input connector — Attach a cable from the
2
computer source to this 15-pin HD female connector.
Audio input connector — Plug a 3.5 mm stereo plug into this
3
jack for unbalanced audio input. Wire the male plug as shown
below.
Tip (L)
Sleeve (GND)
Ring (R)
Tip (L)
Sleeve (GND)
Horizontal shift control knob (H. shift) — While viewing the
4
displayed image, rotate this control to move the image to the
right or left on the screen. The power/signal LED flashes green
whenever the minimum and maximum limits of this control are
reached.
2-12
RGB 580xi • Installation and Setup
All manuals and user guides at all-guides.com
through
in the Installation Overview
8
4
3
RGB 580xi S AAP
SHIFT
AUDIO IN
COMPUTER IN
RGB 580xi
1
2
3
4
RGB 580xi SI AAP
SELECT
SHIFT
AUDIO IN
COMPUTER IN
RGB 580xi
1
5
2
DDSP disables the horizontal shifting control.
Input select button — Pressing this button results in contact
5
closure between pins A and B of the contact closure control
connector on the front panel of the RGB 580xi.
Cabling the AAP Device Rear Connectors
Extron's various AAP devices for the RGB 580xi may come with
several rear connectors that may require cabling.
Although the VGA and control cable/LED assembly
comes prewired to the captive screw connectors, any
subsequent cable assembly replacement will require the
following cabling instructions.
To cable the captive screw connectors, refer to the following
diagrams and orient the wires according to the view angle of
the captive screws. When using Extron's VGA and control cable
assembly (see appendix A, "Optional RGB 580xi AAP Extension
Cables" for part numbers), refer to the color of each wire for
signal identification.
H. SHIFT
Red
Black
Yellow
White
Pink
Example of AAP device rear connectors
Control connector (J4) — Insert wires into and tighten the
1
screws on the 3.5 mm, 5-pole captive screw connector. This
connector is used for contact closure and horizontal shifting
signals. Wire the connector as shown in the following
illustration.
RGB 580xi • Installation and Setup
AUDIO
INPUT
COMPUTER
SELECT
RGB 580xi SI AAP
3
Lt. Blue
1
Purple
2
Green
Gray
2-13
Advertisement
Table of Contents
