Sim2 Multimedia SpA User Manual page 21

INFO
This function displays the current status of the projector, input
type, input frequency, etc.
Info
Mode
Source
Standard Video
Horiz Frequency
Video Type
Aspect
Color Temperature
Lamp Hour Meter
Software Version
LANGUAGE
ENGLISH
ITALIANO
FRANCAIS
DEUTSCH
ESPANOL
PORTOGUES
QUICK MENUS
The Quick menus allows the adjustment of most of the picture
quality controls without recalling the main On Screen menus.
Brightness, Contrast, Color, Tint, Sharpness and Filter
adjustments appear at the bottom of the screen, one after
another, when Up and Down Arrow keys are pressed.
4:3
Video
NTSC 60Hz/4.43MHz
15.7kHz
Normal
Panoramic
Low
362
2.08 H P (038)
VIDEO
RGB
MESSAGES
The following messages could appear on your screen:
No Signal
The projector does not recognise any signal sent through the
selected input.
- Check that the selected input is actually connected to
a video or graphic signal.
- Verify compatibility of video/graphic signals with technical
specifications of your projector.
- Check the integrity of cables used to connect various
sources.
Out of range
Either the resolution or the horizontal/vertical frequency of the
input signal is too high.
- Input a signal that is within specifications.
High temperature
The projector detects temperature internally; if it is too high it
will switch itself off.
- Check temperature of the room: it must be below 35°C
(95°F)
- Check projector air vents on top and underneath the projector:
they must be free of obstruction.
- If the problem persists, consult your Dealer.
21