Sim2 Multimedia SpA User Manual page 10

SWITCHING OFF AND RETURNING TO STAND-BY
By remote control: press
By keyboard: press key
When switching off, the projector goes in to stand-by
memorising the input selection at the time of switch-off.
STATE
POWER OFF
INITIALIZATION
STANDBY
OPERATING
COOLING LAMP
WARNING
ERROR
6 CONNECTIONS
To obtain the best performance from your projector, we
recommend the use of good quality "video cables" to the various
signal sources (75 ohm Impedance).
Poor quality cables will cause inferior picture performance.
For optimum connectivity we recommend you follow these
simple steps:
- With exception of coaxial RCA/Phono type connectors,
always double-check that the plug is inserted the correct
way round to avoid damaging the plugs or the sockets on
the projector (Fig. 15) ..
10
INDICATORS
GREEN RED
OFF OFF
ON ON
OFF ON
ON OFF
FLASHING FLASHING
OFF
FLASHING
OFF FLASHING
The fans will continue to work until the lamp has cooled down
(red and green LEDs flashing) and will stop automatically after
this period.
LED INDICATORS
The LED indicators, located in the top-rear of the projector,
provide information about the state of the projector (see table
below).
The Power is turned off
Power button has been pressed and the software is initialized (15 s)
Projector is in standby mode
Projector is on
Projector is powering down; the fans are running to cool the lamp (1 min)
Problems to display one or more source
Internal circuit failure
- Remove cables by the plug and do not pull on the cable
itself.
- Avoid tangled cables.
- Position the cables carefully to avoid a trip hazard - especially
in low light areas.
NOTES
Fig. 15