NAME
applynetwork - apply XSCF network information to the XSCF
SYNOPSIS
applynetwork [[-q] -{y|n}] [-M]
applynetwork -h
DESCRIPTION
applynetwork(8) command applies XSCF network information that has been set
to the XSCF.
Setting network information on XSCF is a three-step process:
1. Set the information with the following commands:
■
■
■
■
2. Execute the applynetwork(8) command to apply the settings to XSCF.
3. Execute the rebootxscf(8) command to make the changes to the XSCF
permanent.
Note – If XSCF is reset without executing the applynetwork(8) command,
network information that is set is not applied in XSCF. Also, information that is set
is deleted.
You must have platadm privileges to run this command.
Privileges
Refer to setprivileges(8) for more information.
OPTIONS
The following options are supported:
-h
-M
-n
-q
-y
EXTENDED
■
DESCRIPTION
sethostname(8) - Set XSCF host name and a DNS domain name
setnameserver(8) - Set a DNS server name and a DNS search path
setnetwork(8) - Set IP address and netmask of XSCF network interface
setroute(8) - Set routing information of XSCF network interface
Displays usage statement. When used with other options or
operands, an error occurs.
Displays text by page.
Automatically answers "n" (no) to all prompts.
Suppresses all messages to stdout, including prompts.
Automatically answers "y" (yes) to all prompts.
When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
applynetwork(8)
System Administration
35