Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 146

rebootxscf(8)
EXAMPLES
EXIT STATUS
SEE ALSO
132 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised February 2010
By using the rebootxscf(8) command, you can reset XSCF while the domain is
■
in operation. However, if you set up XSCF to serve as the upper NTP server of
the domain, time lag may arise between XSCF and the domain. In such a case,
adjust the domain time so that XSCF and the domain will be synchronized.
Resets the XSCF.
EXAMPLE 1
XSCF> rebootxscf
The XSCF will be reset. Continue? [y|n]:y
Resets the XSCF. Automatically replies with "y" to the prompt.
EXAMPLE 2
XSCF> rebootxscf -y
The XSCF will be reset. Continue? [y|n]:y
Resets the XSCF. Automatically replies with "y" without displaying the
EXAMPLE 3
prompt.
XSCF> rebootxscf -q -y
Cancels the rebootxscf(8) command execution that is in progress.
EXAMPLE 4
XSCF> rebootxscf
The XSCF will be reset. Continue? [y|n]:n
XSCF>
The following exit values are returned:
Successful completion.
0
An error occurred.
>0
applynetwork(8), setaltitude(8), setdualpowerfeed(8), sethttps(8), setntp(8),
setssh(8), settelnet(8)