Axis A1001 Installation Manual page 28

3. Strip the cables and wires as required using a crimp tool.
4. Connect the wires between the door controller and the locks, doors and other devices. For
more information about the connectors and their specifications, see page 14 and page 17.
NOTICE NOTICE NOTICE
• Make sure all the wires are connected correctly. Incorrect wiring could cause damage
to the product.
• The cables shall have wire diameters that correspond to AWG 28–16 (CSA) or
AWG 30–14 (CUL/UL). For more information, see Specifications, on page 16.
Cable connection example
1 6-pin plug connector
2
Network cable
3
Cable tie (4x)
4
Network connector
AXIS A1001 Network Door Controller
28