Axis A1001 Installation Manual page 18

Reader I/O Connector
6-pin terminal block for:
• Auxiliary power (DC output)
• Digital Input
• Digital Output
• 0 V DC (-)
Function Pin
1
0 V DC (-)
2
DC output
3–6
Configurable
(Input or
Output)
Door Connector
Two 4-pin terminal blocks for door monitoring devices (digital input).
Function Pin
1, 3
0 V DC (-)
2, 4
Input
AXIS A1001 Network Door Controller
Notes
For powering auxiliary equipment.
Note: This pin can only be used as
power out.
Digital input — Connect to pin 1 to
activate, or leave floating (unconnected)
to deactivate.
Digital output — Connected to
pin 1 when activated, floating
(unconnected) when deactivated. If
used with an inductive load, e.g. a relay,
a diode must be connected in parallel
with the load, for protection against
voltage transients.
Notes
For communicating with door monitor.
Digital input — Connect to
pin 1 or 3 respectively to activate,
or leave floating (unconnected) to
deactivate.
Note: This pin can only be used for
input.
18
Specifications
0 V DC
12 V DC
Max load = 300 mA
0 to max 40 V DC
0 to max 40 V DC, open
drain, 100 mA
Specifications
0 V DC
0 to max 40 V DC