Axis A1001 Installation Manual page 15

AXIS A1001 Network Door Controller
• Digital output – For connecting, for example, reader beepers and reader LEDs.
Door Connector
Two 4-pin terminal blocks for connecting door monitoring devices and request to exit (REX) devices
Auxiliary Connector
4-pin configurable I/O terminal block. Use with external devices, in combination with, for example
tampering alarms, event triggering and alarm notifications. In addition to the 0 V DC reference
point and power (DC output), the auxiliary connector provides the interface to:
• Digital input – An alarm input for connecting devices that can toggle between an open
and closed circuit, for example PIR sensors or glass break detectors.
• Digital output – For connecting external devices such as burglar alarms, sirens or lights.
Connected devices can be activated by the VAPIX® application programming interface or
by an action rule.
External Power Inputs
NOTICE
NOTICE NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC), on
page 2 .
Power Connector
2-pin terminal block for DC power input. Use a Safety Extra Low Voltage (SELV) compliant limited
power source (LPS) with either a rated output power limited to ≤100 W or a rated output current
limited to ≤5 A.
Network Connector
RJ45 Ethernet connector. Supports Power over Ethernet (PoE).
Power Outputs
Power Lock Connector
4-pin terminal block for connecting one or two locks. The lock connector can also be used to
power external devices.
Power & Relay Connector
6-pin terminal block for connecting power and the door controller's relay to external devices
such as locks and sensors.
Buttons and Other Hardware
Tampering Alarm Pin Header
Two 2-pin headers for disconnecting the front and back tampering alarms.
15