9. Disconnect the product from the network. If not powering the product through Power
over Ethernet, also disconnect the product from its power source.
To cancel the hardware configuration, click Cancel. This can be done in any of the hardware
configuration pages.
To view the hardware pin chart, go to Setup > Hardware Pin Chart.
To print the hardware pin chart, click Print Hardware Pin Chart.
To delete the hardware configuration, click Reset hardware configuration for this controller.
To delete and reconfigure the hardware configuration, click Reset and start new hardware
configuration.
Wall and Ceiling Mount
NOTICE
NOTICE
NOTICE
If installing the door controller on a wall, make sure the cut-out for the cables is facing
downwards.
1. If using a junction box, install the junction box before installing the network door
controller.
2. If required, remove the cover screw, insert a slotted screwdriver into the cover removal
slot and remove the cover. See Hardware Overview, on page 11.
3. Make marks for the screw holes in the ceiling/wall, using the base as a template.
4. If required, drill holes for the screws.
5. Mount the base on the wall or ceiling. Make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
AXIS A1001 Network Door Controller
24