System Configuration - Sharp IV-S51M Instruction Manual

When an IV monitor is not directly connected
100V AC
AC-DC Converter
commercially available
power supply
24V DC
General-purpose serial
I/F (RS-232C/RS-422)
(Accessory for the IV-S51M)
Parallel output
(16 output terminals)
Parallel input
(16 input terminals)
Programmable controller
(Note)
• Only connect or disconnect the camera
connectors while the power is OFF.
• Push the convex side of the connector
into the concave side of the mating
connector. When the connector is all the
way on, it clicks. To disconnect the
connector, hold the plug of the connector,
and pull it straight out.
• You must have a camera connected to the
camera1 connector.

1. System Configuration

Extension terminal
RS-232C/RS-422
IV-S51M
Controller
USB terminal
USB terminal
100BASE-TX/10BASE-T
Analog RGB output
Monitor cable
IV-S50MC2
For future extension (USB storage, etc.)
USB mouse,
USB trackball
Supporting tool IV-S50SPM
Optical system selection expert
Commercially available analog RGB monitor
LCD monitor for IV-08MP
(built-in touch panel)
Camera cable
IV-S30KC3(3m)
Standard camera
IV-S30KC5(5m)
IV-S30KC7(7m)
Camera cable
IV-S30KC3(3m)
IV-S30KC5(5m)
IV-S30KC7(7m)
Camera cable
IV-S30KC3(3m) High-speed camera
IV-S30KC5(5m)
Camera cable
IV-S30KC3(3m)
IV-S30KC5(5m)
1 - 1
Power supply module for lighting, etc.
Standard lens
(IV-S30C1)
(IV-S20L16)
Micro camera
(IV-S30C2)
(off-the-shelf product)
Standard lens
(IV-S30C3)
(IV-S20L16)
Micro, high-speed camera
(IV-S30C4)
ø17 lens
ø17 lens
(off-the-shelf product)