Sharp IV-S51M Instruction Manual page 16

Image sensor camera
Table of Contents

Advertisement

When the LCD monitor IV-08MPand the controller are separately used, connect the IV monitor
cable (IV-S50MC2: to be sold separately) to the connector for IV monitor (IV MONITOR ONLY).
(Note) When the LCD monitor and the controller are directly connected, the work described
here is not required.
When other commercially available analog RGB monitor with SVGA display function are
connected other than the LCD monitor, connect the monitor cable to the analog RGB monitor
connector (ANALOG RGB).
See the individual manual for each camera for details about connection/installation of the camera.
Leave enough space around the IV-S51M
In order to connect camera cables, the IV monitor cable, RGB monitor cable and Ethernet cable to
the IV-S51M, the following space (min.) is required.
(Note)
• Do not bend the camera cables repeatedly.
• Make sure the installation location allows the enough space for the input/output wires going to
the I/O terminal block and the power terminal block on the IV-S51M.
(1) Vertical placement
* When the IV-S51M is vertically
placed, make sure that the space
of at least 10 mm is secured at the
top and the backside of IV-S51M.
81
105
23.2
100mm
(minimun)
USB
LAN
RGB
CAMERA
IV MONITOR
10
136.4
Mounting surface
3 - 8
80
23.2
Provide the space by more than 10 mm.
Provide the space
by more than 10 mm.
126.4

Advertisement

Table of Contents
loading

Table of Contents