[ 3 ] Connecting the peripheral equipment to the IV-S51M
Connect the camera (up to 2 cameras), the LCD monitor, and commercially available analog RGB
monitor to the IV-S51M.
Camera 1 connector
Camera 2 connector
Connect the camera cable (IV-S30KC3/KC5/KC7) or the camera conversion cable (IV-S30HC) to
the camera 1 connector (CAMERA 1) and camera 2 connector (CAMERA 2) on the IV-S51M.
(Note) Only connect or disconnect the peripheral equipment including the camera while the
power is OFF.
• Push the convex side of the connector into the concave side of the mating connector. When
the connector is all the way on, it clicks.
• To disconnect the connector, hold the plug of the connector and pull it straight out.
• A camera connected to the camera 1 connector (CAMERA 1), is treated as camera 1 by this
system, and a camera connected to the camera 2 connector (CAMERA 2) is treated as
• It is possible to connect only one camera. In this case, you must have a camera connected to
the camera 1 connector.
3 - 7
Analog RGB monitor connector
Analog RGB monitor cable
Connector for exclusive monitor
(IV MONITOR ONLY)
IV monitor cable
(IV-S50MC2: to be sold separately)
analog RGB monitor