Table of Contents
Advertisement
Viewing and Printing a Read Status
4.4 Viewing and Printing a Read Status
To view or print Read Status information follow the instructions below:
Option
Read Point
Print Points
Read History
Print History
Read Alarm History
Print Alarm History
NOTE: If attempting to read a point that is not installed, the control panel displays "Not Installed".
During all Read Status operations (except print operations) the control panel starts a 2-minute timer
each time you press a key. If the control panel does not detect a key press for 2 minutes, the control
panel exits Read Status and returns to the "System Normal" display.
In Read Status, you can also do the following:
•
Press the
•
Press the S
4.4.1 How to View Read Status of Devices, Zones, & System Settings
Overview
Read Point options 0, 2, and 4 in the Read Status Screen let you display and view information for
devices and zones programmed into the control panel, as well as view system and annunciator
settings. This section provides instructions and sample displays so you can view Read Status.
Topics covered in this section:
To view Read Status for
Intelligent Detectors
Control/relay and Monitor
modules
NAC
Software Zones (Z01-Z99)
Special Zones (F0-F9)
Releasing Zones (R0-R9)
System Functions
Annunciator Selections
NFS-320/E/C, NFS-320SYS/E Operations Manual — P/N 52747:E1 06/16/2011
Press
Lets you
0 key,
key
View information for a detector, module, NAC or zone
ENTER
1 key,
key
Print information for all installed points in the system
ENTER
2 key,
key
Display the total number of events in the History buffer and step
ENTER
through each event in sequence
3 key,
key
Print the contents of the History buffer (up to 800 events)
ENTER
4 key,
key
View a display of the number of alarms in the Alarm History buffer,
ENTER
then scroll through each alarm event
5 key,
key
Print the contents of the Alarm History buffer (up to 200 events)
ENTER
key to delete the previous entry.
ESC
R
key to abort Read Status.
YSTEM
ESET
Refer to
"How to View Read Status for a Detector" on page 36
"How to View Read Status for a Control/Relay or Monitor
Module" on page 37
"How to View Read Status for a NAC" on page 38
"How to View Read Status for a Software Zone (Z01-Z99)"
on page 39
"How to View Read Status for a Special Zone (F0-F9)" on
page 39
"How to View Read Status for a Releasing Zone (R0-R9)"
on page 40
"How to Read Status for System Functions" on page 40
"How to Read Status for Annunciator Selections" on
page 41
Read Status Operation
35
Advertisement
Table of Contents
