Cleaning The Cn50 - Intermec CN50 User Manual

Cleaning the CN50

CN50 Mobile Computer User's Manual
2
4 Press to select Force Cold Boot and then press
Continue with Boot.
The CN50 executes the clean boot. This process takes a few
minutes.
5 When prompted, tap the screen to set up the CN50.
6 Follow the instructions to calibrate the screen.
To keep the CN50 in good working order, you may need to perform
these minor maintenance tasks:
• Clean the scanner window.
• Clean the CN50 screen.
Clean the scanner window and CN50 screen as often as needed for the
environment in which you are using the computer. To clean the
CN50, use a solution of one part ammonia and 3 parts water.
There are no user-serviceable parts inside the CN50. Opening the
unit will void the warranty and may cause damage to the internal
components.
To clean the scanner window and computer screen
^
1 Press to turn off the CN50.
2 Dip a clean towel or rag in the ammonia solution and wring out
the excess. Wipe off the scanner window and screen. Do not allow
any abrasive material to touch these surfaces.
3 Wipe dry.
Chapter 4 — Troubleshooting and Maintaining the CN50
0
to select
57