Resetting The Cn50; Warm Booting The Cn50 - Intermec CN50 User Manual

Resetting the CN50

Warm Booting the CN50

CN50 Mobile Computer User's Manual
Problems While Scanning Bar Codes (continued)
Problem
The scanned bar
code data that
appears in your
application does
not match the data
encoded in the bar
code label.
You rarely need to reset the computer. If the computer does not
resume after pressing the
application lock up, you may need to reset the CN50. The CN50 uses
the configuration currently saved in flash memory during the boot
process. There are three ways to reset the CN50:
• Warm booting
• Cold booting
• Clean booting
You may need to perform a warm boot to correct conditions where an
application stops responding to the system.
To warm boot the CN50
Go to Start > Programs > Shut Down. The CN50 systematically
•
shuts down.
The computer goes through the initialization process and restarts.
Chapter 4 — Troubleshooting and Maintaining the CN50
Possible Solution
The CN50 may have decoded the bar code label in a
different bar code symbology. Try scanning the bar
code label again. Make sure you scan the entire label.
^
button, or if the computer or an
55