Intermec PB21 User Manual page 44

Chapter 2 — Configuring the PB21 and PB31
32
3 Click File > Add printer.
Or, in the General Tasks list, click Add printer.
4 Click Next.
5 Select Serial, then click Next.
6 Make sure that the COM Port is set to the correct serial port, and
that Automatically detect communication parameters is
selected. Click Next.
7 PrintSet attempts to connect to your printer. If it cannot find your
printer, click Back to review the communication settings, then try
again. When PrintSet connects to your printer, click Next.
8 Click Finish. Your printer appears in the My Printers list.
To connect the printer to a PC through the serial port using
HyperTerminal
1 Connect the serial cable to the connector on the back of the
printer and connect the other end to your PC.
2 On your PC, start the communications program.
3 If necessary, configure the port settings so they match those of
your printer.
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: XON_XOFF
4 If you are using HyperTerminal
a Click OK.
b Click the Settings tab.
c Click ASCII Setup. The ASCII Setup window appears.
d Check the following check boxes, then click OK:
• Send line ends with line feed
Echo typed characters locally
•
• Append line feeds to incoming line ends
PB21 and PB31 Mobile Receipt Printer User's Guide