Assembly - ProForm PFEL2595.0 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver
mallet .
See the drawings below to identify the small parts needed for assembly. The number in parenthesis below
each drawing is the key number of the part, from the PART LIST on page 14. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a
part is not found in the parts bag, check to see if it has been pre-assembled.
M8 Split
Washer (74)–7 Washer (17)–4
M20 Wave
Washer (71)–2
M10 x 22mm Button
Screw (21)–4
Bolt Set (27)–2
M8 Large M10 Split
Washer (67)–8
M4 x 16mm M4 x 19mm
Screw (66)–4 Screw (39)–2
M8 x 42mm Button
Bolt (50)–4
M10 x 105mm Carriage Bolt (34)–2
, two adjustable wrenches
M8 Nylon M10 Nylon
Locknut (46)–4 Locknut (29)–2
M8 x 19mm Button
Screw (22)–4
M10 x 58mm Button Screw (19)–4
4
, and a rubber
M16 Wave
Washer (83)–2
M8 x 25mm Button
Screw (57)–3
M8 x 48mm Button
Screw (20)–4