Table of Contents
Advertisement
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires a phillips screwdriver
(not included).
1. With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (137) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (117) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (115).
With the help of a second person, carefully raise the
treadmill to the upright position so that both Extension
Legs (137) are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions on page 11 to lower
the treadmill.
Next, remove the nut, bolt, and shipping bracket from the
left Upright (102).
3. Insert any slack in the Wire Harness (108) into the right
Upright (102). Next, insert the brackets on the Console
Base (92) into the Uprights as shown. Firmly tighten four
Handrail Bolts (141) with Handrail Nuts (142) into the
Uprights and the Console Base.
6
137
117
2
Shipping Bracket
102
3
142
141
92
102
115
108
142
141
Advertisement
Table of Contents
