Assembly - ProForm RAZOR 400 ES User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver ,
adjustable wrench , and rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.
M6 Nylon Wave Washer M10 Split M10 x 20mm Patch M10 x 35mm Shoulder
(88)–2
Locknut (77)–4 Washer (78)–10 Screw (79)–4 Screw (63)–2
M4 x 16mm M4 x 16mm M4 x 32mm Screw
M4 x 12mm
Screw (84)–10 (95)–2
Round Head
Screw (99)–4
Screw (94)–4
M6 x 16mm Patch
M6 x 36mm Button
M10 x 70mm Button Screw (75)–6
Screw (80)–6
Bolt (76)–4
5