Assembly - ProForm 14.0 CE User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s) and grease packet(s), assembly requires a Phillips
screwdriver and a rubber mallet .
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M6 Washer M8 Split Washer M8 Washer Wave Washer
M4 x 19mm
(118)–2
(95)–6 Screw (156)–8
(112)–8
(103)–14
M6 x 12mm Patch M6 x 50mm Patch M8 x 16mm Patch
M8 x 25mm Patch
Screw (111)–4 Screw (62)–4 Screw (102)–16
Screw (121)–2
M8 x 35mm Patch M10 x 95mm Patch
Screw (149)–2 Screw (100)–4
5