Assembly - ProForm 590 E User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M8 Split 16mm Wave 19mm Wave M10 Washer
M8 x 25mm
Washer (54)–2 Washer (66)–4
(95)–2
Washer (83)–13
Washer (98)–6
M8 Locknut M10 Locknut M4 x 16mm M8 x 16mm Patch M8 x 19mm Patch
(102)–4 (92)–2 Screw (104)–10 Screw (110)–4 Screw (82)–15
M8 x 38mm M8 x 80mm Patch
Bolt (96)–4 Screw (84)–2
M10 x 60mm
M10 x 45mm Patch
Screw (99)–4 Bolt (100)–2
5