How To Use The Elliptical Exerciser - ProForm PFEL2595.0 User Manual

11. Apply a thin film of grease to the shaft of a Bolt Set
(27) and to the axle on the left Crank Arm (36).
Slide the Left Pedal Arm (14) onto the axle on the left
Crank Arm (36). Attach the Left Pedal Arm with an M8
x 19mm Button Screw (22), an M8 Large Washer
(17), and an M20 Wave Washer (71). Make sure that
the Wave Washer is on the end of the axle.
Attach the Left Handlebar Leg (73) to the Left Pedal
Arm (14) with the Bolt Set (27).
See step 8 on page 7. Tighten the M8 x 42mm Button
Bolts (50). Make sure that the M8 Nylon Locknuts
(46) are seated in the hexagonal holes.
Attach the Right Pedal Arm (16) to the right side of
the elliptical exerciser in the same way.
12. Make sure that all parts of the elliptical exerciser are properly tightened. Place a mat under the elliptical
exerciser to protect the floor or carpet from damage.

HOW TO USE THE ELLIPTICAL EXERCISER

HOW TO EXERCISE ON THE ELLIPTICAL
EXERCISER
To mount the elliptical exerciser, firmly hold the han-
dlebars and carefully step onto the pedal that is in the
lowest position. Next, step onto the other pedal. Push
the pedals until they begin to move with a continuous
motion. Note: The pedal disks can turn in either
direction. It is recommended that you turn the
pedal disks in the direction shown at the right;
however, for variety, you can turn the pedal disks
in the opposite direction.
To dismount the elliptical exerciser, allow the pedals
to come to a complete stop. CAUTION: The elliptical
exerciser does not have a freewheel; the pedals
will continue to move until the flywheel stops.
When the pedals are stationary, step off the highest
pedal first. Then, step off the lowest pedal.
11
73
Grease
27
Handlebars
8
16
36
14
17
22
Grease
71
Pedal
Pedal Disk