Checks After Starting Engine; Cooling Water - Yamaha LF200 Owner's Manual

Operation
3. Turn the main switch to "
TIP:
Dual engine users: When the main switch is
turned on, the buzzer operates for a few sec-
onds then stops automatically. The buzzer
also operates if one of the engines stalls.
4. Turn the main switch to "
and hold it for a maximum of 5 seconds.
54
ON ON
OFF START OFF START
ZMU05828
" (on).
" (start),
ON
START
ZMU04596
ON
START
5. Immediately after the engine starts, re-
lease the main switch to return it to "
(on). NOTICE: Never turn the main
switch to "
gine is running. Do not keep the start-
er motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 sec-
onds, the battery will be quickly dis-
charged, thus making it impossible to
start the engine. The starter can also
be damaged. If the engine will not start
after 5 seconds of cranking, return the
main switch to "
onds, then crank the engine again.
[ECM00192]
EMU36510

Checks after starting engine

EMU36523

Cooling water

Check for a steady flow of water from the cool-
ing water pilot hole. A continuous flow of water
from the pilot hole indicates that the water
pump is pumping water through the cooling
water passages. If the cooling water passag-
es are frozen, it may take a while for water to
start flowing out of the pilot hole.
ECM01810
NOTICE
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
ZMU05830
" (start) while the en-
" (on), wait 10 sec-
"