Operating Instructions; Proofer; For The Standard Manual-Fill Proofer; Fig. #4 ...................................... Manual Fill Proofer Controls - Nu-Vu SUB-123 Owner's Manual

Oven / proofer

Hide thumbs

Table Of Contents

Table of Contents

SUB–123 OWNER'S MANUAL

PROOFER:

Fig. #4 – Manual Fill Proofer Controls

For the Standard Manual Fill Proofer - -

Begin to pre-heat the Proofer section of the SUB-123 about 20 to 30 minutes before its scheduled use.

A. Set out the desired product for thawing. Be sure to allow sufficient time in your

schedule for both the product and your equipment to reach the correct conditions.

Prepare the Proofer:

Set the Proofer Power Switch [31] to ON.

Set the Proofer Temperature Control [32] to the required setting (refer to the GENERAL

SETTINGS on page 18). Begin preheating the Proofer at least 20 minutes prior to its

scheduled use.

Set the Proofer Humidity Control [34] to the required setting (refer to the GENERAL

SETTINGS on page 18). Manual fill units require time to heat the water and raise the internal

humidity level; these units must be started at least 20 minutes before use.

Make sure the Water Pan [64] contains no less than 1" of water. The water level should be

checked every time you load the Proofer, and at least every other hour during operations. Use

warm water whenever you refill the pan.

The Proofer is ready for use when the Temperature and Humidity Indicator Lights go out and

a light to moderate fogging appears on the Proofer Door [42].

IMPORTANT: ALWAYS REDUCE THE HUMIDITY SETTING TO A MINIMAL LEVEL

WHEN OPERATING THE PROOFER FOR EXTENDED PERIODS WITHOUT ANY

Load the product. The pans should be pushed all the way back and centered from side to side as

much as possible on each Proofer Shelf to allow for proper air circulation over and around your

product. If you are loading a single pan, center it on the Shelf from side to side and front to back.

NOTE: The Indicator Lights will turn on and off as the Temperature and Humidity Controls

regulate the conditions in the Proofer. This is normal and may happen several times during a

proofing cycle.

NU-VU

FOOD SERVICE SYSTEMS

(800) 338-9886