Fig. #2 ...................................... Power Supply Connections; Fig. #3 ...................................... Changing Electrical Phases - Nu-Vu SUB-123 Owner's Manual

SUB–123 OWNER'S MANUAL
Fig. #2 – Power Supply Connections
E. Carefully set all switches and controls on the front of the unit to their OFF positions and engage
the main power supply.
F. Check the voltage at the terminals on the Power Terminal Block with a voltmeter and compare the
readings with the label listings on the side of the unit. If the readings match, the unit is ready for its
initial START-UP. If the readings DO NOT coincide you must call the NU-VU
Department for instructions on changing the voltage and/or the phase.
NOTE: Diagrams and abbreviated instructions for phase-changing can be found in Fig. #3 below,
but only to help you understand the procedure that we will explain to you!!! DO NOT change the
phase of your equipment without first calling the NU-VU
Fig. #3 – Changing Electrical Phases
®
NU-VU FOOD SERVICE SYSTEMS
(800) 338-9886 Sales Fax (906) 863-5889 ♦ Service Fax (906) 863-6322
RECEIPT, INSTALLATION AND START-UP
®
Service Department!
MENOMINEE MICHIGAN 49858-0035
®
Service
5
page